Spline Mesh Component doesn't render if two spline points are directly above and below each other

Spline Mesh Component doesn't render if two spline points are placed exactly above and below each other. If they are offset by any value other than 0.0, the Spline Mesh component will be rendered as expected.

1. Open the attached test project
2. Select the BP_Spline blueprint
3. Select the upper most spline point
4. In the Details panel, select the Spline component
5. Below > Selected Points > Chance the X value of Position to 0.0001

Results: If the spline points are placed directly above and below one another, they Spline Mesh component isn't rendered, but if they are offset by any value other than 0.0, the Spline Mesh component will be rendered

Expected: For the Spline Mesh component to be rendered regardless of where the spline points are located